Hi Edu
The config is incorrect.
In the module chain part, you can give the module key any arbitrary name, such as Swap.
Make sure the module key that you used in the top part for Processing Sequence matches EXACTLY the module key in the bottom part for Module Configuration.
Then in the lower section for module configuration, it should be as follows:-
| Module Key | Parameter Name | Parameter Value |
|---|---|---|
| Swap | swap.keyName | Payload-Name |
| Swap | swap.keyValue | document-1 |
You can check a sample screenshot of how the PayloadSwapBean configuration used in the following Wiki (at end of step 2)
Rgds
Eng Swee
Message was edited by: Eng Swee Yeoh